Socket Repair
by: Ron
Francis Wiring
Your original sockets can be looking pretty bad, and a
simple clean up may not be the answer, since the socket inserts are
usually worn, sloppy and corroded.
After removing the old socket from the housing you can clean and paint
it. Sometimes a slight enlargement of the socket hole to 3/4" is
necessary. Then you are ready to install the billet
socket with either a single or a double filament depending on your
needs.
Tighten the nut and everything is ready to go!
Don't forget to use dielectric grease on the base of the bulbs!
The outcome is years of trouble-free lights with a quality socket that
will stay in shape!
Return To Article Index
Return Home
Wiring
Harness by Ron Francis